Normally Open Contact Symbol

Like the notc contact this type of contact is normally open when the coil is unpowered de energized and closed by the application of power to the relay coil.

Normally open contact symbol.

In a schematic diagram the switch symbol appears to be a toggle switch with a flag hanging below. If the contact is normally open it would not allow any current to pass through it and hence there will be an open circuit at this contact. Usually at about 75 speed of motor. This is the switch used to operate a doorbell.

Normally open switch contacts are sometimes referred to in the electrical industry as form a contacts. Also now is a good time to remind you that this is article is talking about the electrical normally open and normally closed symbols which while may look the same as the. This symbol is used to indicate normally close contact. Next we have the normally open timed open noto contact.

Note the following symbols. Energizing it and switching it on will close the contact causing it to allow current flow. If we had used a normally closed pushbutton switch instead the behavior would be exactly opposite. The contacts are nc normally closed and open when the back emf is high enough to pull the contacts open and take the start capacitor out of the circuit.

In other words when voltage is applied to the relay contactor terminals this contact closes. Relays and contactors have two types of contacts each suited for different applications. Normally open contacts are designated by the lines not touching while normally closed contacts are designated with a diagonal line bridging between the two lines. Normally closed nc contacts allow current through when the relay or contactor is not energized.

Form c contacts change over or transfer contacts are composed of a normally closed contact pair and a normally open contact pair that are operated by the same device. Normally open is a contact that does not flow current in its normal state. This type of push switch is normally closed on it is open off only when the button is pressed. The given symbol indicates a normally open contact.

There is a common electrical connection between a contact of each pair that results in only three connection terminals. There is also a generic symbology for any switch contact using a pair of vertical lines to represent the contact points in a switch. On off switch spst spst single pole. Normally open no contacts allow current when the relay or contactor is energized.

Push switch push to make a push switch allows current to flow only when the button is pressed.