See below for a shopping list and tools subscribe to this.
Old door enlarge existing door handle hole.
Mark the center of the existing hole on the edge of the door.
Use a hole saw to drill through the plywood and halfway through the door.
Turn the door over remove the plywood disk from the hole saw and use the hole saw to drill through the other side of the door until the two holes meet.
When enlarging a lockset hole mark the centerlines of the old hole on the door.
Measure the size of the existing hole in your door using a tape measure.
This old house general contractor tom silva installs an undetectable wood patch in an old door.
Clamp a piece of plywood to each side of the door lining up the center lines with the center line on the door edge.
The door handles in this house were set too high 1 4m.
2 draw a circle on a sheet of plywood measuring the same size as the hole in your door using a compass to make the circle.
The plywood will hold the pilot bit on track until the saw starts cutting.
Mar 25 2016 explore bruce wiseman s board home.
See more ideas about doors door color painted doors.
Then mark centerlines on the plywood block.